- Liquidation happens when the remaining margin falls below the maintenance level.
- The higher the leverage, the closer the liquidation price is to your entry: at 10× a move of about 10% is enough.
- Isolated margin limits the loss to one position; cross margin puts the whole futures account at stake.
- Liquidation follows the mark price, not a random spike from a single trade.
- Your balance does not go negative, but you can lose the entire margin.
What is liquidation in plain words?
Think of margin as a deposit you put up for a position. Leverage shows how many times larger the position is than the deposit: 100 USDT of margin at 10× opens a 1,000 USDT position. Profit and loss are calculated on the whole position but taken from the margin.
While the price moves your way, the margin grows. When it moves against you, it shrinks. Once what is left drops below the minimum needed to keep the position open, the system closes it. That is liquidation. It exists so that the loss does not exceed the collateral you put up.
Understand this clearly: liquidation is not a penalty or a system error but a built-in rule of futures. When you trade with leverage, you accept that a certain price move will close the position and take the margin. That is why Nexus Pay requires a risk quiz before your first futures trade, and the spot and futures page says it plainly: you can lose your entire margin.
What are initial margin and maintenance margin?
There are two kinds of margin, and they are easy to mix up.
Initial margin is what you put up when opening a position. It depends on position size and leverage: the higher the leverage, the smaller the initial margin for the same position.
Maintenance margin is the minimum that must remain for the position to stay open. In Nexus Pay it is currently 0.5% of the position value up to $50,000 and 1% on the part above that. These are current settings and the operator can change them.
Example: a 1,000 USDT position needs 5 USDT of maintenance margin. If you opened it with 100 USDT of margin, the position has a 95 USDT buffer for losses. When losses eat that buffer, liquidation triggers.
The takeaway is simple: liquidation comes not when the margin hits zero but slightly earlier, when what is left reaches the maintenance level. Opening fees and funding payments also shrink the buffer.
Why is a move of about 10% enough at 10× leverage?
Because leverage multiplies the price move. Take 100 USDT of margin at 10×: the position is 1,000 USDT. If the price moves 10% against you, the loss is 100 USDT, the entire margin. Allowing for maintenance margin and fees, liquidation comes even a little earlier.
The same calculation for other leverage levels is in the table below. The higher the leverage, the smaller the move that wipes out the position. At 20×, a swing of about 5% is enough, which for crypto is an ordinary day and sometimes an ordinary hour.
This is not theory: exactly this question appears in the mandatory quiz before the first trade. In a long, a price drop triggers liquidation; in a short, a rise does. More on directions in our article on long and short. To get a feel for how sharp moves can be, read what happens to your balance when the price drops.
| Leverage | Position with 100 USDT margin | Price move against you that eats the margin |
|---|---|---|
| 2× | 200 USDT | about 50% |
| 5× | 500 USDT | about 20% |
| 10×, the default | 1,000 USDT | about 10% |
| 20×, the main set's cap | 2,000 USDT | about 5% |
How is isolated margin different from cross margin?
The margin mode decides what is at stake when liquidation hits.
Isolated margin is tied to a single position. If it is liquidated, you lose that position's entire margin, and the rest of your futures collateral is untouched. It is a clear mode for beginners because the maximum loss is known in advance.
Cross margin uses all the collateral in your futures account to support every position at once. The upside is that a temporary drawdown in one position is covered by free funds, so liquidation moves further away. The downside is that if the move continues, liquidation takes all the collateral in your futures account, not just one position.
Put simply:
- isolated: the most you lose is what you set aside for the trade;
- cross: liquidation is further away, but the stake is higher, the whole futures account.
If you are unsure which to choose, pick isolated and low leverage.
What is the mark price and why does liquidation use it?
The mark price is a calculated fair price for the contract, not the price of the last trade. The last trade can briefly stray far from the market because of one large order; the mark price smooths out such outliers. That is why liquidation in Nexus Pay is based on the mark price: a random spike on its own should not close your position.
Take-profit and stop-loss can be tied to either the mark price or the last price. The first is steadier against outliers; the second reacts faster.
If the market moves so sharply that the price jumps past the liquidation level, your balance does not go negative: you will not lose more than your futures collateral. That is still no reason to relax, because the margin is lost in full.
How can you lower the risk of liquidation?
You cannot remove the risk from futures entirely, but you can make it clear and manageable:
- Lower the leverage. The default is 10×; lower means further from liquidation.
- Use isolated margin until you have experience.
- Set a stop-loss above the liquidation price for a long and below it for a short, so the position closes with a smaller loss.
- Shrink the position size, not just the leverage: risk only what you are ready to lose.
- Account for the funding rate when holding for long: payments gradually change your remaining margin.
- Avoid opening positions on news, when prices jump more than usual.
If you want experience without leverage, start with spot; the difference is covered in spot vs futures. This is not financial advice: leveraged trading can cost you your entire margin.
